cNODE® is a family of transponders for underwater acoustic positioning and data link, and operates with both HiPAP®, HPR and cPAP® transceivers. The cNODE® transponders operates with either the HiPAP® / HPR 400 channels and telemetry or with the new Cymbal acoustic protocol.
The cNODEMaxi 31 Exd transponders are made especially for operating in an explosive atmosphere.
Two models are available :
• cNODE Maxi 31-80V-90-Exd.
• cNODEMaxi 31-80V-Exd.
The cNODEMaxi 31 Exd transponders comply with the following standards :
• IEC/EX 60079-1:2007
• IEC 60079-0:2011
• IEC 60086-1
• EN 60079-0:2012
Bolts and tube:……………………..Super Duplex stainless steel
Transducer, top end cap and bottom end cap:………Titanium grade 5
Operation depth :………………………………………………..1000 m
Operating frequency :…………………………..21 kHz to 31 kHz
Communication principle :………………….Phase Shift Keying (Cymbal) and Frequency Shift Keying (FSK)
Transducer beam width :……………………………….80° at -3 dB
Frequency band :……………………….Medium frequency (MF)
Source level :……………………………………………………..198 dB
Receiver sensitivity :……………………………………………..85 dB
cNODE Maxi 31-80V-90-Exd
Width :……………………………………………………………..164 mm
Height :…………………………………………………………….874 mm
Weight in air :…………………………………………………….35.5 kg
Weight in water :…………………………………………………..25 kg
cNODE Maxi 31-80V-Exd
Width :…………………………………………………………..139.5 mm
Height :…………………………………………………………….880 mm
Weight in air :…………………………………………………….35.5 kg
Weight in water :…………………………………………………..25 kg
Battery type :….Non-rechargeable Lithium metal, (Li/SOC2)
Operating voltage :………………………………….10 to 14.4 VDC
Battery output :………………………………………………14.4 VDC
Total battery energy content :……………………………….128 Ah
Cells per battery :……………………………………………………….48
Type of cells :……………………………………………………Lithium
Power consumption (peak operation) :……………………250 W
Power consumption average :…………………………………3.6 W
(Presumed High Tx power and ping rate 1 sec.)
Operation temperature :……………………………..-5°C to +55°C
Storage temperature :………………………………-30°C to +70°C
Read more :
Wireless position sensor GNOM DP S7 is used in transport telematics systems (GPS/GLONASS vehicle monitoring…
Pressure sensor GNOM DDE is used to determine the axle load in vehicles equipped with…
Axle Load Sensor GNOM DP Technoton position sensor is designed for measuring axle and cargo…
FMSCrocodile is used within for vehicle telematics system as a ready-made solution for safe integration…
Contactless J1708 Reader Technoton is designed for safe data reading from J1708 bus (SAE J1587)…
CANCrocoLITE Technoton — is a tool for Telematics systems used for data reading from on-board…
This website uses cookies.
View Comments