The working principle is a capacitive measurement operating on absorption of water in oil. The physical measured value is % Humidity. New oil has the ability to hold a certain amount of dissolved water. The maximum water amount oil can hold is called “saturation point”. Above the “saturation point” free water will fall out which can cause corrosion inside of the engine. The “saturation point” is influenced by temperature and other different factors like the composition of oil mineral or synthetic, formulation of additives and will change during the lifetime of the oil. The Water in Oil Sensor (WiO) is not measuring free water or emulsion, which is detectable by regular Water in Oil test kits, it measures the absolute water content in oil.
The PAV (Pre Alarm Value) is set to 50% humidity. The MAV (Main Alarm Value) is set to 90% humidity.
More than 100% humidity means free water is present. From this point regular Water in Oil test kits begin to measure.
Normally in the field, the water in oil content is measured by a Water in Oil test kit. The results are mostly <0.02% (or 100.02% humidity), this value means free water content. If the WiO Sensor shows the main alarm, the value is higher than 90% humidity and damage could be caused to the engine if 100% humidity is reached.
- Condition monitoring Lubrication oil including :
- – 2 and 4 stroke engines
- – Compressors
- – Pumps
- – Gear boxes
- – Turbines
- Condition monitoring for Hydraulic oil including;
- – All machines using hydraulic oil up to 10bar
- Measures the absolute water content in oil.
- Early warning by using pre alarm and alarm
- – The PAV (Pre Alarm Value) is set to 50% humidity.
- – The MAV (Main Alarm Value) is set to 90%.
- Takes the oil temperature into consideration in order to measure the saturation.
- The sensor measures the saturation of the oil independent from the oil type and oil age.
- No cleaning of the sensor is needed.
|Power Supply||18…32 VDC|
|Alarm relays||Pre-alarm at 50% humidity|
Main alarm at 90% humidity
|Operating Temperature||-25 to +85 0C|
|Analog Output: Water in Oil||4…20 mA (equiv. 0…100% Humidity Linear)|
|Analog Output: Temperature||4…20 mA (equiv. 0…1000C Linear)|
|Dimensions:||125mm x 80mm x 57mm|
|Local Indication||LED Indicators|
|Sensor Probe Specification|
|Wrong Polarity Protection||Yes|
|Operating temperature||-25 to 85 0C|
|Pressure resistance against medium||10 bar|
|Connection type||G3/4” Male Thread|
|Material||Stainless Steel AISI 303; 1.4305|
|Dimensions||50mm x 187mm|
|Cable Length to Controller||15m|
|Local indication||LED Indicators|
|Indicator Dial Temperature||Indicator Dial Humidity|
|Indicator Dial type||Analog needle type||Indicator Dial type||Analog needle type|
|Unit of Measurement||Degrees Celsius||Unit of Measurement||% Humidity|
|Range||0 – 1000C||Range||0% – 100% Humidity|
|Dimensions||96mm x 96mm x 77mm||Dimensions||96mm x 96mm x 77mm|
Specifications and system descriptions accurate at time of printing. These are subject to change.
Read more SMARTSAFE ORB (Oil Record Book); SMART BILGE 15PPM OIL CONTENT MONITOR; SMART PFM 107 OIL IN WATER MONITOR; SMART ODME FOR MARINE; SMART ESM – Exhaust Scrubber Washwater Monitor; Smart Turbidity For Marine; OCD 50M OIL IN WATER MONITOR; OCD CW COOLING WATER MONITOR