Rheonik Mass Flow Technology 

All Rheonik Coriolis mass flow sensor is based on a patented Omega tube design with an increased signal-to-noise ratio, for excellent performance and reliability. The combination of a patented torsion rod swinger with the Omega shape and support bars results in high accuracy measurement independent of pressure, even at very low flow velocities.

RHM Coriolis mass flow sensors are extremely resistant to gas bubbles entrained in the process stream. And it is unaffected by viscosity, density, extreme temperatures, and pressure changes. There’s a Rheonik RHM mass flow sensor for nearly any flow application range.

The typical Omega-shaped Rheonik Coriolis mass flow sensors. All Rheonik meters are principally based on the design shown beside. No other design offers this degree of versatility and rangeability :

•  Measurement of liquid and gaseous fluids.
• Flow rates from 0.002 to 30,000 kg/min (0.004 to 66,000 lbs/min).
• Diameters up to 12 inches / DN 300.
•  Pressure over 1,000 bar (14,500 psi).
• Temperature from -196°C to +395°C (-320°F to +743°F).
• Hazardous area certified versions available (ATEX, CSA etc.)
• Available in stainless steel, Alloy C22, Duplex, Tantalum, and others.

THE RHEONIK OMEGA TUBE DESIGN

The Rheonik Omega Tube meter mechanism consists of three distinct sections :

The Measurement Section

• Pickup Coils – provide signals to the transmitter.
• Measurement Tubes – the part of the meter where the measurement takes place.

The Meter Drive System

• Mass Bars – provide stability and support to the measurement tube oscillation.
• Drive Coils – provide power to maintain oscillations at a constant amplitude.
• Torsion Rods – help energize and guide oscillation.

The Meter Connection System

• In/Out Section – decouples measurement tubes from process line stress and misalignment.

Each section plays a specific role in ensuring that the meter performs at a high level when measuring flow. The following information briefly describes the role of the various components within the flow meter. And, how they interact to ensure accurate and reliable flow measurement, even in difficult conditions.

RHM Coriolis flow sensors offer a direct mass flow rate for liquids, sludge, and gases, all with high accuracies. These sensors are extremely resistant to gas bubbles entrained in the process stream and are unaffected by viscosity, density, extreme temperatures, and pressure changes. There’s a Rheonik RHM flowmeterfor nearly any flow application range :

The capacity of Rheonik RHM Coriolis flow sensor

Kind of Coriolis Mass Flow Meter from RHEONIK

• Small Size Coriolis Mass Flow Sensor
  • Ideal for embedded systems and precise small flow applications
    • RHM 015 Low Flow Mass Flow Meter flow rate
    • RHM 02 Low Flow Mass Flow Meter flow rate
    • RHM 03 Low Flow Mass Flow Meter flowrate
    • RHM 04 Low Flow Mass Flow Meter flow rate
    • RHM 06 Low Flow Mass Flow Meter flowrate
    • RHM 08 Low Flow Mass Flow Meter flow rate