| 1. GENERAL | |
| Frequency Ranges: | TX: 156.025 MHz – 157.425 MHz |
| RX: 156.050 MHz – 161275 MHz | |
| Channel spacing | 25 kHz |
| Frequency stability | ±5 ppm |
| (-4 °F to +140 CF (-20 ‘C to +60 CC]) | |
| Emission Type: | 16K0G3E |
| Antenna Impedance : | 50 ? |
| Operating Voltage: | HX100: 4.8 V DC, Negative Ground |
| HX150: 7.4 V DC, Negative Ground | |
| Current Consumption: | HX100: 300 mA (Receive, Typical at AF MAX.) |
| HX150: 300 mA (Receive, Typical at AF MAX.) 15 mA (Standby) | |
| HX100: 1.1 Al 0.8A (TX: 2.5 W / 1 W) | |
| HX150: 1.5 A/ 0.7 A (TX: 5 W/ 1 W) | |
| Battery Life (Approx ) | HX100: 7.5 hours (5/5/90 duty cycle) |
| HX150: 10 hours (5/5/90 duty cycle) | |
| Operating Temperature: | —4 °F to +140 °F (-20 °C to +60 °C) |
| Case Size (W x H x D): | 2.4″ x 5.3″ x 1.5″ (62 x 135 x 38.5 mm) |
| (w/o knob & antenna) | |
| Weight (Approx.): | HX100: 8.6 oz (245 g)(with FNB-125, Belt Clip) |
| HX150: 8.3 oz (235 g)(with FNB-124LI, Belt Clip) | |
| 2. TRANSMITTER | |
| RF Power Output | HX100 : 2.5 W/ 1 W (@4.8 V) |
| HX150 : 5W / 1W (@7.4 V) | |
| Modulation Type | Variable Reactance |
| Maximum Deviation | ±5 kHz |
| Spurious Emission | —60 dBc typical |
| Microphone Impedance : | 2 k? |
| 3 RECEIVER | |
| circuit Type: | Direct-Conversion Superheterodyne |
| Adjacent Channel Selectivity : | 65 dB typical |
| Intermodulation: | 65 dB typical |
| 1-14im & Noise Ratio: | 40 dB typical |
| Sensitivity: | 0-3 ?V for 12 dB SINAD |
| Selectivity: | 25 kHz (-6.5 dB) |
| AF Output (Internal SF’): | HX100 : |
| 500 mW @16 ? for 10 % THD (@4.8 V | |
| HX150 : | |
| 500 mW @16 ? for 10 % THD (@7.4 V | |
| Measured in accordance with TWEIA-503. | |
Floating Handheld VHF Twin Pack
Features :
The HX100 comes value packed with two floating Handheld VHF radios and a dual charging station to charge both radios simultaneously when not in use.
New intuitive menu system allows easy access to all of the setup functions of the radio, making it easy to customize settings based on the preferences of the user.
Read more :
Wireless position sensor GNOM DP S7 is used in transport telematics systems (GPS/GLONASS vehicle monitoring…
Pressure sensor GNOM DDE is used to determine the axle load in vehicles equipped with…
Axle Load Sensor GNOM DP Technoton position sensor is designed for measuring axle and cargo…
FMSCrocodile is used within for vehicle telematics system as a ready-made solution for safe integration…
Contactless J1708 Reader Technoton is designed for safe data reading from J1708 bus (SAE J1587)…
CANCrocoLITE Technoton — is a tool for Telematics systems used for data reading from on-board…
This website uses cookies.
View Comments