When the compressor in the reefer circuit starts and suddenly stops, it can be because of the following reasons :
| Reasons | Solutions |
| Low pressure cut out gets activated | Ensure that all the suction line valves are in open condition, the refrigeration is properly charged and the low pressure cut out is not defective |
| Defective oil pressure cut out | Check for proper functioning of oil pressure cutout and replace the defective cutout |
| Defrosting timer is getting activated frequently | If the defrost timer is getting activated frequently, leading to cutout of compressor, check and repair defrost timer |
| The lube oil level is below required level | This can be because of leakage of lube oil from seal or carry over of oil. Rectify the leakage and refill the oil level |
| Foaming of oil leading to reduced oil pressure | Ensure no foaming takes place, renew the oil if required |
| Motor overload cutouts are activating | Ensure that electrical motor trips are working properly |
DFM is designed for fuel consumption measurement in fuel lines of vehicles and stationary machines,…
DUT-E S7 wireless sensor allows measuring current fuel volume and its changes in a fuel…
Various fuel types (summer diesel, winter diesel and especially biodiesel) have different permittivity values. That…
DUT-E GSM is a 2-in-1 device – fuel level sensor and GPS tracker in one…
DUT-E fuel level sensor is used for accurate fuel level and volume measurement in tanks…
Rheonik Fuel Consumption For Marine Application, Rheonik Coriolis mass flow meters have been used for…
This website uses cookies.